Mechanical properties of nodular natural gas hydrate-bearing sediment

Abstract

Natural gas hydrate is a relatively realistic alternative energy source to conventional fossil fuels with considerable reserves. Natural gas hydrate sediments are widely distributed in marine sediment on continental margins. In this study, a numerical modeling method for sediment containing nodular gas hydrates is developed using the two-dimensional discrete element simulation software. The effects of saturation, confining pressure, and nodule radius on the mechanical properties of heterogeneous nodular gas-hydrate-bearing sediment were analyzed using the stress-strain, fracture development, and partial body strain curves, as well as force chain distribution. The results indicated that the mechanical strength of sediment containing round nodular gas hydrates was proportional to the gas hydrate saturation and simulated confining pressure. When hydrate saturation was low, the failure strength of the gas-hydrate-bearing sediment diminished as the nodule radius increased. The simulations showed that variations in sediment porosity influenced the development and evolution of the shear band, resulting in higher porosity around the shear band. These results were analyzed from the perspectives of saturation and confining pressure to determine the failure and deformation law of simple nodular gas hydrate-bearing sediment and provide theoretical support for the subsequent study of the exploitation method of shallow buried deep gas hydrates.

Document Type: Original article

Cited as: Jiang, Y., Zhang, R., Ye, R., Zhou, K., Gong, B., Golsanami, N. Mechanical properties of nodular natural gas hydrate-bearing sediment. Advances in Geo-Energy Research, 2024, 11(1): 41-53. https://doi.org/10.46690/ager.2024.01.05

References

Aregbe, A. G. Gas hydrate-properties, formation and benefits. Open Journal of Yangtze Oil and Gas, 2017, 2(1): 27-44.

Bai, B., Zhou, R., Yang, G., et al. The constitutive behavior and dissociation effect of hydrate-bearing sediment within a granular thermodynamic framework. Ocean Engineering, 2023, 268: 113408.

Boswell, R. Engineering. Is gas hydrate energy within reach? Science, 2009, 325(5943): 957-958.

Boswell, R., Collett, T. S. Current perspectives on gas hydrate resources. Energy & Environmental Science, 2011, 4(4): 1206-1215.

Brugada, J., Cheng, Y. P., Soga, K., et al. Discrete element modelling of geomechanical behaviour of methane hydrate soils with pore-filling hydrate distribution. Granular Matter, 2010, 12(5): 517-525.

Collett, T. S. Energy resource potential of natural gas hydrates. AAPG Bulletin, 2002, 86(11): 1971-1992.

Collett, T. S., Kuuskraa, V. A. Hydrates contain vast store of world gas resources. Oil and Gas Journal, 1998, 96(19): 90-94.

Dai, S., Seol, Y. Water permeability in hydrate-bearing sediments: A pore-scale study. Geophysical Research Letters, 2014, 41(12): 4176-4184.

Demirbas, A. Methane hydrates as potential energy resource: Part 1-importance, resource and recovery facilities. Energy Conversion and Management, 2010, 51(7): 1547-1561.

Dong, L., Wu, N., Zhang, Y., et al. Improved duncan-chang model for reconstituted hydrate-bearing clayey silt from the south china sea. Advances in Geo-Energy Research, 2023, 8(2): 136-140.

Gong, B., Jiang, Y., Yan, P., et al. Discrete element numerical simulation of mechanical properties of methane hydrate-bearing specimen considering deposit angles. Journal of Natural Gas Science and Engineering, 2020, 76: 103182.

Gong, B., Zhang, R., Sun, T., et al. Coupling model of submarine deformation response prediction during methane hydrate exploitation. Energy & Fuels, 2022, 36(13): 6785-6809.

Hyodo, M., Li, Y., Yoneda, J., et al. Mechanical behavior of gas-saturated methane hydrate-bearing sediments. Journal of Geophysical Research: Solid Earth, 2013, 118(10): 5185-5194.

Hyodo, M., Nakata, Y., Yoshimoto, N., et al. Bonding strength by methane hydrate formed among sand particles. Paper Presented at Powders and Grains 2009: Proceedings of the 6th International Conference on Micromechanics of Granular Media, 13-17 July, 2009.

Itasca, C. G. Pfc-pfc 6.0 documentation. Itasca Consulting Group Minneapolis, MN, 2018.

Jensen, R. P., Bosscher, P. J., Plesha, M. E., et al. Dem simulation of granular media-structure interface: Effects of surface roughness and particle shape. International Journal for Numerical and Analytical Methods in Geomechanics, 1999, 23(6): 531-547.

Jiang, M., Liu, J., Shen, Z. Dem simulation of grain-coating type methane hydrate bearing sediments along various stress paths. Engineering Geology, 2019, 261: 105280.

Jiang, M., Peng, D., Ooi, J. Y. Dem investigation of mechanical behavior and strain localization of methane hydrate bearing sediments with different temperatures and water pressures. Engineering Geology, 2017, 223: 92-109.

Jiang, Y., Gong, B. Discrete-element numerical modelling method for studying mechanical response of methane-hydrate-bearing specimens. Marine Georesources & Geotechnology, 2020, 38(9): 1082-1096.

Kumar, P., Sonawane, A. Engineering significance and consequences of gas hydrates in deep and ultra deep water development. Paper ISOPE-I-04-042 Presented at ISOPE International Ocean and Polar Engineering Conference, Toulon, France, 23-28 May, 2004.

Li, Y., Dong, L., Wu, N., et al. Influences of hydrate layered distribution patterns on triaxial shearing characteristics of hydrate-bearing sediments. Engineering Geology, 2021a, 294: 106375.

Li, Y., Li, J., You, Z., et al. A particle-scale investigation of mechanical behavior of cemented hydrate-bearing sediment using discrete element method. Geomechanics for Energy and the Environment, 2023, 33: 100436.

Li, Y., Liu, L., Jin, Y., et al. Characterization and development of natural gas hydrate in marine clayey-silt reservoirs: A review and discussion. Advances in Geo-Energy Research, 2021b, 5(1): 75-86.

Li, Y., Song, Y., Yu, F., et al. Effect of confining pressure on mechanical behavior of methane hydrate-bearing sediments. Petroleum Exploration and Development, 2011a, 38(5): 637-640.

Li, Y., Song, Y., Yu, F., et al. Experimental study on mechanical properties of gas hydrate-bearing sediments using kaolin clay. China Ocean Engineering, 2011b, 25(1): 113-122.

Linga, P., Clarke, M. A. A review of reactor designs and materials employed for increasing the rate of gas hydrate formation. Energy & Fuels, 2016, 31(1): 1-13.

Liu, H., Guo, P., Zhan, S., et al. Experimental investigation into formation/dissociation characteristics of methane hydrate in consolidated sediments with resistance measurement. Fuel, 2018, 234: 985-995.

Madhusudhan, B. N., Clayton, C. R. I., Priest, J. A. The effects of hydrate on the strength and stiffness of some sands. Journal of Geophysical Research: Solid Earth, 2019, 124(1): 65-75.

Makogon, Y. F., Holditch, S. A., Makogon, T. Y. Natural gas-hydrates — a potential energy source for the 21st century. Journal of Petroleum Science and Engineering, 2007, 56(1-3): 14-31.

Masui, A., Miyazaki, K., Haneda, H., et al. Mechanical characteristics of natural and artificial gas hydrate bearing sediments. Paper ICGH 2008 Presented at the 6th International Conference on Gas Hydrates, Vancouver, British Columbia, Canada, 6-10 July, 2008.

Miyazaki, K., Masui, A., Tenma, N., et al. Study on mechanical behavior for methane hydrate sediment based on constant strain-rate test and unloading-reloading test under triaxial compression. International Journal of Offshore and Polar Engineering, 2010, 20(1): 61-67.

Moridis, G. J., Collett, T. S., Pooladi-Darvish, M., et al. Challenges, uncertainties, and issues facing gas production from gas-hydrate deposits. SPE Reservoir Evaluation & Engineering, 2011, 14(1): 76-112.

Ning, F., Liang, J., Wu, N. Reservoir characteristics of natural gas hydrates in China. Natural Gas Industry, 2020, 40(8): 1-25. (in Chinese)

Priest, J. A., Hayley, J. L., Smith, W. E., et al. Pcats triaxial testing: Geomechanical properties of sediments from pressure cores recovered from the bay of bengal during expedition nghp-02. Marine and Petroleum Geology, 2019, 108: 424-438.

Rutqvist, J., Moridis, G. J., Grover, T., et al. Geomechanical response of permafrost-associated hydrate deposits to depressurization-induced gas production. Journal of Petroleum Science and Engineering, 2009, 67(1-2): 1-12.

Seol, J., Lee, H. Natural gas hydrate as a potential energy resource: From occurrence to production. Korean Journal of Chemical Engineering, 2013, 30(4): 771-786.

Sloan, E. D. Clathrate hydrate measurements: Microscopic, mesoscopic, and macroscopic. The Journal of Chemical Thermodynamics, 2003, 35(1): 41-53.

Vinod, J., Hyodo, M., Indraratna, B., et al. Dem modelling of methane hydrate bearing sand. Australian Geomechanics Journal, 2014, 49(4): 175-182.

Wan, Y., Yuan, Y., Zhou, C., et al. Multiphysics coupling in exploitation and utilization of geo-energy: State-of-the art and future perspectives. Advances in Geo-Energy Research, 2023, 10(1): 7-13.

Wang, D., Ning, F., Lu, J., et al. Reservoir characteristics and critical influencing factors on gas hydrate accumulations in the Shenhu area, South China sea. Marine and Petroleum Geology, 2021a, 133: 105238.

Wang, H., Chen, Y., Zhou, B., et al. Investigation of the effect of cementing ratio on the mechanical properties and strain location of hydrate-bearing sediments by using dem. Journal of Natural Gas Science and Engineering, 2021b, 94: 104123.

Wang, X., Sun, Y., Li, B., et al. Reservoir stimulation of marine natural gas hydrate-a review. Energy, 2023, 263: 126120.

Whiticar, M. J., Faber, E., Schoell, M. Biogenic methane formation in marine and freshwater environments: CO2 reduction vs. Acetate fermentation—isotope evidence. Geochimica et Cosmochimica Acta, 1986, 50(5): 693-709.

Winters, W. J., Waite, W. F., Mason, D. H., et al. Methane gas hydrate effect on sediment acoustic and strength properties. Journal of Petroleum Science and Engineering, 2007, 56(1-3): 127-135.

Wu, Q., Dou, X., Zhao, Y., et al. Discrete element simulation of the hydrate-bearing sediments mechanical behaviors under typical hydrate dissociation patterns. Gas Science and Engineering, 2023, 115: 205020.

Yang, Q., Zhao, C. Three-dimensional discrete element analysis of mechanical behavior of methane hydrate-bearing sediments. Rock and Soil Mechanics, 2014, 35(1): 255-262. (in Chinese)

Yoneda, J., Kida, M., Konno, Y., et al. In situ mechanical properties of shallow gas hydrate deposits in the deep seabed. Geophysical Research Letters, 2019, 46(24): 14459-14468.

You, Z., Wu, P., Sun, X., et al. Effect of hydrate distribution on the mechanical response of hydrate-bearing sand: Discrete element method simulation. Energy & Fuels, 2022, 36(7): 3802-3815.

Yun, T. S., Santamarina, J. C., Ruppel, C. Mechanical properties of sand, silt, and clay containing tetrahydrofuran hydrate. Journal of Geophysical Research: Solid Earth, 2007, 112(B4): B04106.

Zeng, S., Mao, L., Liu, Q., et al. Study on mechanical properties of natural gas hydrate production riser considering hydrate phase transition and marine environmental loads. Ocean Engineering, 2021, 235: 109456.

Zhang, G., Liang, J., Yang, S., et al. Geological features, controlling factors and potential prospects of the gas hydrate occurrence in the east part of the pearl river mouth basin, South China sea. Marine and Petroleum Geology, 2015, 67: 356-367.

Zhang, N., Wang, H. N., Jiang, M. J. A mesoelastic-plastic damage model for hydrate-bearing sediments with various hydrate-growth patterns. Ocean Engineering, 2022, 266: 112919.

Zhang, X., Lu, X., Li, Q., et al. Thermally induced evolution of phase transformations in gas hydrate sediment. Science China Physics, Mechanics and Astronomy, 2010, 53: 1530-1535.

Zhao, M., Liu, H., Ma, Q., et al. Discrete element simulation analysis of damage and failure of hydrate-bearing sediments. Journal of Natural Gas Science and Engineering, 2022, 102: 104557.